P33 to P33 Power Cable: Direct 3-Phase Power for Antminer S21 and T21

Valiant Power P33 to P33 3-phase mining power cable

Bigger mining farms eventually move to 3-phase power. It moves more energy through the same amount of copper, balances load across the electrical system, and is what most large PDUs are designed around. On the newest Bitmain hardware, that 3-phase connection often runs through P33 connectors.

The Valiant Power P33 to P33 Power Cable connects P33 to P33 directly, with no adapters in the path.

P33 to P33 Power Cable

P33 to P33 Power Cable

From $34.99

Buy Now

Why 3-phase in a mining farm?

  • More power per circuit. Three-phase delivers more total power than single-phase for the same current per conductor.
  • Balanced load. Spreading miners across three phases keeps the electrical service balanced, which utilities and electricians like.
  • Fewer runs. Bigger PDUs on 3-phase mean fewer separate circuits to pull and manage.

If your site is single-phase, this is not the cable for you. Talk to your electrician before mixing equipment.

About the cable

The P33 is a 6-pin connector. This cable uses 5-conductor copper wiring to carry the three phases plus the conductors needed for a complete 3-phase connection and grounding. The connectors lock, so vibration from miner fans will not work them loose over time.

Specs

Connectors P33 to P33, 6-pin, locking
Power 3-phase
Wiring 5-conductor copper
Wire 12AWG
Lengths 3 ft, 6 ft, 10 ft

Compatible equipment

  • Antminer S21, T21, and S19XP models with P33 connections
  • Compatible Bitmain mining systems
  • P33-compatible mining PDUs and power infrastructure

Confirm that both your PDU output and the equipment it feeds are P33 before ordering. If the miner side is P13, use a P33 to P13 cable instead.

Picking a length

  • 3 ft: equipment right next to the PDU
  • 6 ft: most rack runs
  • 10 ft: PDU at the end of a row or on a different rack

Safety first

Three-phase mining power is serious. Have a licensed electrician design and inspect the installation, confirm the voltage and phase configuration your equipment expects, and verify every connection before energizing.

Frequently asked questions

Can I use this on single-phase power?

It is designed for compatible 3-phase equipment. Check your equipment and site with an electrician.

Do I need an adapter?

No, as long as both ends of your connection are P33.

Which length is most common?

6 ft covers most standard rack layouts.

P33 to P33 Power Cable

P33 to P33 Power Cable

From $34.99

Buy Now

Questions? Email support@valiantpowerco.com. Or see the P33 to P33 Cable.

C13 to C14 Power Cords: The Rack Cable Everyone...
C15 vs C13: When Your Equipment Needs a C14 to ...