C13 to C14 Power Cords: The Rack Cable Everyone Uses and How to Pick One

Valiant Power C13 to C14 IEC power cord

Look behind almost any server rack and most of the cords you see are the same: C13 to C14. It is the standard connection between a PDU and the equipment it powers. Servers, switches, routers, storage, firewalls. If it lives in a rack, there is a good chance it takes this cord.

The Valiant Power C13 to C14 Power Cord comes in five lengths so you can match each run instead of stuffing extra cable behind the rack.

C13 to C14 Power Cord

C13 to C14 Power Cord

From $5.99

Buy Now

C13 vs C14: which end is which?

Both come from the IEC 60320 standard, the one that defines most equipment power connectors worldwide.

  • C14 is the male end, with three pins. It plugs into a C13 outlet on a PDU.
  • C13 is the female end, with three holes. It plugs into the C14 inlet on your equipment.

So a C13 to C14 cord runs from the device (C13 end) to the PDU (C14 end). It is essentially an extension for IEC connections, and the most common cord in any data center.

How it compares to other IEC cords

Cord Use it for
C13 to C14 Standard servers, switches, storage from C13 PDU outlets
C14 to C15 Equipment with hot-running C16 inlets, like some network gear
C19 to C20 High-draw gear with C20 inlets, from C19 PDU outlets

Why 14AWG

Lots of cheap C13 cords use 18AWG wire, the thin stuff that comes in the box with a monitor. It works for light loads. This cord uses 14AWG, which is noticeably heavier. Thicker wire runs cooler under steady load, and rack equipment is always under steady load.

Specs

Connectors C13 female to C14 male
Rating 10A, 250V
Wire 14AWG
Lengths 1 ft, 3 ft, 5 ft, 7 ft, 10 ft

Picking lengths for a clean rack

The fastest way to make a rack look professional is to stop using one length for everything. Rough guide:

  • 1 ft: device directly next to a vertical PDU outlet
  • 3 ft: horizontal PDU a few U away from the device
  • 5 ft: routing through side cable management
  • 7 ft: top of the rack to the bottom
  • 10 ft: rack to rack, or equipment on a separate shelf

Measure the actual path the cord will take, including any cable management arms, then round up to the next length.

Frequently asked questions

Is a C13 cord the same as a computer power cord?

The C13 end is the same as the end on a typical desktop or monitor cord. The difference is the other end: this one has a C14 for PDUs instead of a wall plug.

Can I use it on 120V?

Yes. It is rated up to 250V, so it works on 120V, 208V, and 240V PDUs.

Will it fit a C19 outlet?

No. C19 outlets need a C20 plug.

C13 to C14 Power Cord

C13 to C14 Power Cord

From $5.99

Buy Now

Ordering for a full rack? Email support@valiantpowerco.com. Or see the C13 to C14 Cords.

P33 to P33 Power Cable: Direct 3-Phase Power fo...
C15 vs C13: When Your Equipment Needs a C14 to ...