L6-30P to P13 Power Cord: The Simple Way to Power One Miner Per Circuit

Valiant Power L6-30P to P13 power cord

The simplest mining setup there is: one miner, one circuit, one cord. No splitters, no load math across multiple machines, no PDU to manage. If a breaker ever trips, you know exactly which miner caused it.

The Valiant Power L6-30P to P13 Power Cord makes that connection directly, from an L6-30R twist-lock receptacle to a miner with a P13 inlet.

L6-30P to P13 Power Cord

L6-30P to P13 Power Cord

From $24.99

Buy Now

Why one miner per circuit works so well

  • Plenty of headroom. A 30A circuit at 240V can carry about 5,760 watts continuously. A single current-generation miner sits comfortably inside that, even with overclocking headroom.
  • Easy troubleshooting. A trip affects one machine, not a rack.
  • Fewer connection points. Every adapter or splitter is another spot that can heat up or work loose. This is wall to miner, nothing in between.

What P13 is

P13 is the power inlet on many newer Bitmain miners. Older units used C14 or C20 inlets that fit standard IEC cords. P13 needs a P13 cord, which is why this cable exists. Check the inlet on your miner before ordering. If it is labeled P13, this fits.

Specs

Input NEMA L6-30P twist-lock
Output P13
Rating 30A, 250V
Wire 12AWG, 100% copper
Lengths 3 ft, 6 ft, 10 ft

Picking a length

  • 3 ft: receptacle right at the shelf
  • 6 ft: the typical mining rack layout
  • 10 ft: receptacles mounted high or across an aisle

Keep cords as short as will reach. Extra slack coiled near a miner's exhaust gets hot and gets in the way of airflow.

Other ways to connect P13 miners

Frequently asked questions

Which miners use P13?

Many newer Bitmain models, including S21 series, L9, and KS5 series units. Always check the label on the inlet.

Can I use it on 208V?

Yes. It is rated up to 250V.

Why a twist-lock plug?

Miners vibrate constantly. A twist-lock stays seated in the receptacle instead of slowly backing out.

L6-30P to P13 Power Cord

L6-30P to P13 Power Cord

From $24.99

Buy Now

Questions about your setup? Email support@valiantpowerco.com. Or see the L6-30P to P13 Cord.

Connecting a P13 Miner to C13 PDU Outlets: How ...
Connecting a P13 Miner to C13 PDU Outlets: How ...