If your PDU has C19 outlets, you are already set up for high-draw gear. The only problem is the miner end: newer Antminers use a P13 inlet, and a standard C19 to C20 cord will not fit it.
The Valiant Power C20 to P13 Power Cord solves that with one cable. The C20 end plugs into a C19 outlet on your PDU. The P13 end goes into the miner.
One outlet, one miner
C19 outlets are the heavy-duty sockets on a PDU. They are built for considerably more current than C13 outlets, which makes them a natural fit for a single miner. One C19 outlet, one cord, one machine. No splitter needed.
What "tested up to 4,800 watts" means
This cable family has been tested up to 4,800 watts. That gives you a clear ceiling for planning. Most current-generation miners run in the 3,000 to 3,600 watt range at stock settings, leaving headroom below that tested number. If you are overclocking, check your actual wall draw and stay under 4,800W.
Remember the PDU has its own limit too. A 30A PDU at 240V should carry about 5,760W continuously in total, so you can usually run one heavy miner per C19 outlet but not necessarily a full miner on every C19 at once. Add it up.
Specs
| PDU end | C20 (fits C19 outlets) |
| Miner end | P13 |
| Voltage | 240V |
| Wire | 12AWG copper |
| Tested | Up to 4,800W |
| Lengths | 3 ft, 6.5 ft, 10 ft |
Miners it is made for
Newer Antminers with P13 inlets, including L9, S21, KS5, and AL1 series units. Check your miner's inlet label before ordering.
Which length?
- 3 ft: PDU mounted on the same shelf as the miner
- 6.5 ft: standard mining rack runs
- 10 ft: PDU at the end of a row or on another rack
Related cables
- PDU with only C13 outlets: P13 splitter for C13 outlets
- Direct from an L6-30R receptacle: L6-30P to P13 cord
- From a P33 mining PDU: P33 to P13 cable
Frequently asked questions
Will this fit a C13 outlet?
No. The C20 end only fits C19 outlets.
Can I run a miner over 4,800W on it?
No. Stay within the tested rating.
Does it work with older miners?
Only if they have a P13 inlet. Older units with C14 or C20 inlets need standard IEC cords like our C19 to C20 cord.
Questions? Email support@valiantpowerco.com. Or see the C20 to P13 Cord.